How to install Babbo-Daddo to a hard drive (Hardware Install)

Hardware Install
* This will install Babbo-Daddo on a hard drive and will overwrite anything already on the PC / Laptop
You will need: A USB Flash drive of 512MB or greater

– Download the ISO image of SliTaz 4.0 from the ISO Downloads section on this website.
– Make a bootable USB drive using YUMI (Read the FAQ How to use YUMI to make a USB Live CD)

– Download the ISO image of Babbo-Daddo from the ISO Downloads section on this website.
– Copy the downloaded babbo-daddo ISO file to the root of your USB flash drive.
– Boot your PC or laptop from USB and it will load into Slitaz 4.0
(It may take a minute or two but you don’t need to press or touch anything!)

– Choose your desired language and keyboard layout when prompted.
– Left click on the little spanner icon from the top left menu.
– When prompted re-type the username and password, both “root”, then click OK

– From the new Tazpanel window, high-lite over Install from the toolbar and choose Install SliTaz

– Choose continue Installation from the bottom of the page.

– Select ISO File

– On the bottom left of the desktop, click on Applications, System Tools & launch PCMan File Manager

– Click on your USB Drive in the left hand tab, it is probably called MULTIBOOT
– You should see your babbo-daddo.iso file listed on the right side of the window, if so, highlight the text in the address bar and click copy

(This is to get the correct path to your babbo-daddo iso file)

– Close PCMan File Manager

– Right click just to the right of where you selected ISO file and choose paste

Now add the name of the downloaded iso file
eg. /media/MULTIBOOT/babbo-daddo_v1.0a.iso

– Install Slitaz to partition should be selected as /dev/hda1 or /dev/sda1
– Tick “Format partition as” and select “ext3”

(If no hard drive is available you will have to scroll down the page and click on “Back to Partitioning” then choose “Execute GParted” you can continue the install once you have prepared your hard drive. There is an FAQ on the site covering using GParted)

– Scroll down the page to “Grub” and tick “Install Grub bootloader.”

– Click “Proceed to Slitaz installation.

– The installation shouldn’t take more than a minute or two, when finished you will be prompted to restart, you may have to scroll down the page to see this.

– Remove the “Live” USB and click on restart.
– That’s it, you’ve installed Babbo-Daddo!